| DTC Strategy |
|
- Poor Connector Connection
- Short to Battery or Open in TPS1 Signal Circuit
- Open in TPS Supply Circuit
- Faulty TPS1
|
| Enable Condition |
Case 1 |
|
| Case 2 |
- Ignition "ON"
- Engine operating state idle:
- Pedal value lower than 0.01 % (Pedal sensor 1 voltage 0.859V, not pushed at all)
- TPS setpoint lower than 58%
- TPS1 and TPS2 ratio failure detected or TPS2 failure detected
|
| Threshold Value |
Case 1 |
- TPS1 signal voltage higher than 4.9V
|
| Case 2 |
- TPS1 signal voltage at idle higher than 3.0V
|
| Diagnostic Time |
|
| MIL ON Condition |
|