Component Inspection: Notes
- Ignition "ON" & Engine "OFF" and Using a GDS, clear the DTC.
- Ignition "OFF".
- Disconnect the battery (-) terminal cable from the battery, and wait at least one minutes.
- Disconnect WCS ECU connector.
- Substitute the WCS Module and check for proper operation.
- Is DTC present problem?
YES
- Substitute a known-good WCS ECU and check for proper operation.
If the problem is corrected, replace WCS ECU and then go to "Verification Of Vehicle Repair " procedure and Go to "WCS Reset " procedure.
NO
- Substitute a known-good WCS ECU and check for proper operation.
If the problem is corrected, replace WCS ECU or seat assembly and Go to "WCS Reset " procedure.
- Substitute a known-good WCS ECU and check for proper operation.