Current Adjust Circuit Inspection

■ Check Open or Short in signal circuit 

1. IG KEY "OFF".
2. Disconnect HO2S (S1) connector.
3. IG KEY "ON" & ENG "OFF"
4. Measure the voltage between Current Adjust terminal of HO2S (S1) harness connector and chassis ground.

   Specification:  Approx 2.8V

5. Is the measured voltage within specification?

   YES 

   • Go to "Component Inspection " procedure.

   NO 

   • Repair Open or Short circuit and then, go to "Verification of Vehicle Repair " procedure.