Repair Procedures: Removal
WARNING: This page is about a different variant/trim than selected.
- Turn the ignition switch OFF and disconnect the battery negative (-) terminal.
- Remove the resonator and the air intake hose.
(Refer to Engine Mechanical System - "AIR CLEANER ").
- Disconnect the ETC module connector (A).
- Disconnect the coolant hoses (B).
- Remove the mounting bolts (C), and then remove the ETC module from the engine.
Electronic Throttle Body Mounting Bolt:
7.8 - 9.8 N.m (0.8 - 1.0 kgf.m, 5.7 - 7.2 lb.ft)