Engine Coolant Temperature Sensor (ECTS) [Water Temperature Control Assembly]
WARNING: This page is about a different car, the 2017 Kia Niro. However, it is still accessible from the selected car via links, so may be relevant.
- Switch "OFF" the ignition and disconnect the negative (-) battery terminal.
- Remove the air cleaner assembly.
(Refer to Engine Mechanical System - "AIR CLEANER ")
- Remove the purge control solenoid valve.
(Refer to Engine Control/Fuel System - "PURGE CONTROL SOLENOID VALVE (PCSV) ")
- Disconnect the Engine Coolant Temperature Sensor Connector (A).
- Remove the Spring Clip (B), and then pull the sensor from the water temperature control assembly.
Courtesy of KIA MOTORS AMERICA, INC.
NOTE: Note that engine coolant may flow out from the water temperature control assembly when removing the sensor.