Auto Detection Reset Procedure

WARNING: This page is about a different car, the 2017 Kia Niro. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: After replacing the ETC module, the "ECM Auto Detection Reset" procedure must be performed.

Switch "OFF" the ignition.
Connect the KDS/GDS to Data Link Connector (DLC).
Switch "ON" the ignition.
Select "Vehicle, Model year, Engine, System".
Select "Vehicle S/W Management".
Select "ECM Auto Detection Reset".

Fig 1: Screen Display - PCM Auto Detection Reset
Courtesy of KIA MOTORS AMERICA, INC.