Check EOTS

Ignition "OFF".
Disconnect EOTS connector.

Measure resistance between Pin No. 1 (Oil Temperature Sensor) terminal and Pin No. 2 (Sensor Ground) terminal of the EOTS. (Component Side)

Specification: Refer to SPECIFICATION

OIL TEMPERATURE SENSOR SPECIFICATION

Temperature [°C (°F)]	Resistance [kΩ]
-40 (-40)	41.74 to 54.54
-20 (-4)	14.13 to 16.83
0 (32)	5.28 to 6.3
25 (68)	1.88 to 2.14
80 (176)	0.31 to 0.33
140 (284)	0.07 to 0.08

Is the measured value within specification?
YES
- Go to "VERIFICATION OF REPAIR " procedure.
NO
- Carefully re-do this troubleshooting guide steps.
- If no problems were found with the circuits or connectors, replace the EOTS and go to "VERIFICATION OF REPAIR " procedure.