Signal Circuit Inspection
- Ignition "OFF" & Disconnect ETC Motor & TPS connector.
- Ignition "ON".
- Measure voltage between Pin No. 4 (TPS.2 Signal) terminal of ETC Motor & TPS harness connector and chassis ground.
Specification: Approx. 4.9V
- Ignition "OFF" & Disconnect ECM connector.
- Measure resistance between Pin No. 4 (TPS.2 Signal) terminal of ETC Motor & TPS harness connector and chassis ground.
Specification: ∞ (Infinity)Ω
- Is the measured value within specification?
YES
- Go to "COMPONENT INSPECTION " procedure.
NO
- Repair or replace as necessary and then, go to "Verification Of REPAIR " procedure.