Front RH Turn Signal Lamp Circuit Inspection
- Ignition "OFF", disconnect battery (-) terminal.
- Disconnect the IGPM and the Front Right Turn Signal Lamp connector.
- Measure resistance between Pin No. 30 (power) of the IGPM harness connector and Pin No. 3 (power) of the front right turn signal lamp harness connector.
Specification: Approx. below 1Ω
- Is the measured resistance within specification?
YES
- Carefully re-do this troubleshooting guide steps.
- If problem still occurs, replace the IGPM and then go to "Verification Of VEHICLE REPAIR " procedure.
NO
- Repair open in circuit of the front right turn signal lamp, and go to "Verification Of REPAIR " procedure.