Repair Procedures: Disassembly

WARNING: This page is about a different variant/trim than selected.

Disconnect the M-terminal (A) on the magnet switch assembly.

Courtesy of
After loosening the 2 screws (A), detach the magnet switch assembly (B).

Courtesy of
Loosen the brush holder mounting screws (A) and the trough bolts (B).

Courtesy of
Remove the rear bracket assembly (A) and brush holder assembly (B).

Courtesy of
Remove the yoke assembly (A).

Courtesy of
Remove the packing (A), lever plate (B), lever (C), armature assembly (D).

Courtesy of

NOTE: Beware the direction of lever (A).

Courtesy of
Press the stopper (A) using a socket (B).

Courtesy of
After removing the stop ring (A) using stopper pliers (B).

Courtesy of
Remove the stop ring (B), stopper (A), overrunning clutch (C) and armature (D).

Courtesy of

Information
- Using a suitable pulling tool (A), pull the overrunning clutch stopper (C) over the stop ring (B).
  
  Courtesy of