LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2016 >> Sorento SX, FWD >> Repair and Diagnosis >> Brakes >> Traction Control >> Electronic Stability Control (ESC) System >> Troubleshooting >> Communication With GDS Is Not Possible (Communication With ABS Only Is Not Possible) >> Inspection Procedures >> Check The Power Source Of ESC Control Module

Check The Power Source Of ESC Control Module

  1. Disconnect the connector from the ESC control module.
  2. Turn the ignition switch ON, measure the voltage between terminal 29 of the ESC control module harness side connector and body ground.

    Specification:  approximately B+

    Fig 1: Measure Voltage Between Terminal 29 Of ESC Control Module Harness Side Connector And Body Ground
    G11866231Courtesy of KIA MOTORS AMERICA, INC.
  3. Is voltage within specification?

    YES 

    • Check for poor ground.

    NO 

    • Check the harness or connector between the fuse (10A) in the engine compartment junction block and the ESC control module. Repair if necessary.
scientia non olet · About LEMON Manuals