LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2016 >> Sorento SX, 4WD >> Repair and Diagnosis >> Brakes >> Traction Control >> Electronic Stability Control (ESC) System >> Yaw-Rate And G Sensor >> Repair Procedures >> Removal

Repair Procedures: Removal

  1. Remove the ignition key from the vehicle.
  2. Disconnect the battery negative cable and wait for at least three minutes before beginning to work.
  3. Remove the floor console.

    (Refer to Body - "FLOOR CONSOLE ")

  4. Loosen the bolts and then remove the rear air vent duct (A).
    Fig 1: Remove Rear Air Vent Duct
    G11866250Courtesy of KIA MOTORS AMERICA, INC.
  5. Pull up the lock of the SRSCM connector, and then disconnect the connector (A).
    Fig 2: Pull Up Lock Of SRSCM Connector
    G11866251Courtesy of KIA MOTORS AMERICA, INC.
  6. Loosen three (3) SRSCM mounting bolts from the SRSCM, and then remove the SRSCM.
Fig 3: Locate SRSCM Mounting Bolts
G11866252Courtesy of KIA MOTORS AMERICA, INC.
CAUTION: Turn OFF the ignition switch before removing or installing SRSCM or other SRS components to avoid accidental airbag deployment.
scientia non olet · About LEMON Manuals