Repair Procedures: Installation

Wrap tape around the driveshaft spline (TJ) to prevent damaging the boot.
Using the alignment marks (D) made during disassembly as a guide, install the spider assembly (A) and retainer ring (B) on the driveshaft splines (C).

Fig 1: Locate Alignment Marks On Spider Assembly
Courtesy of KIA MOTORS AMERICA, INC.

Fig 2: Locate Alignment Marks On Spider Assembly And Driveshaft Splines
Courtesy of KIA MOTORS AMERICA, INC.
Add specified grease to the joint boot as much as it was wiped away at inspection.
Install the both boot band.
Using the SST (09495-3K000), secure the TJ boot bands.
Clearance (A): 2.0 mm (0.0787 in.) or less

Fig 3: Check TJ Boot Bands Clearance
Courtesy of KIA MOTORS AMERICA, INC.
Install the front driveshaft.
(Refer to Driveshaft Assembly - "FRONT DRIVESHAFT ")