LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2016 >> Sorento L >> Repair and Diagnosis >> Drivelines & Axles >> Axle Shafts >> Driveshaft Assembly >> BJ Boot >> Repair Procedures >> Removal And Installation

Removal And Installation

  1. Remove the front driveshaft.

    (Refer to Driveshaft Assembly - "Front Driveshaft ")

  2. Remove the TJ joint assembly.

    (Refer to Driveshaft Assembly - "TJ Joint ")

  3. Remove the Dynamic damper.

    (Refer to Driveshaft Assembly - "DYNAMIC DAMPER ")

  4. Using a plier or flat-tipped (-) screwdriver, remove the BJ boot bands (A).
    Fig 1: Remove BJ Boot Bands Using Plier Or Flat-Tipped (-) Screwdriver
    G11863691Courtesy of KIA MOTORS AMERICA, INC.
  5. Remove the BJ boot.
  6. Install in the reverse order of removal.
    CAUTION:
    • Do not disassemble the BJ assembly.
    • Special grease must be applied to the driveshaft joint. Do not substitute with another type of grease.
    • The boot band should be replaced with a new one.
scientia non olet · About LEMON Manuals