Anti-Lock Brake System/Electronic Stability Control Diagnosis
- DTC Index
- DTC C1101-01: Battery Voltage High
- DTC C1102-01: Battery Voltage Low
- DTC C1200-01: Wheel Speed Sensor Front-LH Open/Short
- DTC C1201-02: Wheel Speed Sensor Front-LH Range/Performance/Intermittent
- DTC C1202-02: Wheel Speed Sensor Front-LH Invalid/No Signal
- DTC C1203-01: Wheel Speed Sensor Front-RH Open/Short
- DTC C1204-02: Wheel Speed Sensor Front-RH Range/Performance/Intermittent
- DTC C1205-02: Wheel Speed Sensor Front-RH Invalid/No Signal
- DTC C1206-01: Wheel Speed Sensor Rear-LH Open/Short
- DTC C1207-02: Wheel Speed Sensor Rear-LH Range/Performance/Intermittent
- DTC C1208-02: Wheel Speed Sensor Rear-LH Invalid/No Signal
- DTC C1209-01: Wheel Speed Sensor Rear-RH Open/Short
- DTC C1210-02: Wheel Speed Sensor Rear-RH Range/Performance/Intermittent
- DTC C1211-02: Wheel Speed Sensor Rear-RH Invalid/No Signal
- DTC C1213-02: Wheel Speed Frequency Error (Generic Wheel Speed Error)
- DTC C1235-01: Pressure Sensor (Primary) - Electrical
- DTC C1237-02: Pressure Sensor - Other
- DTC C1260-02: Steering Angle Sensor Circuit-Signal
- Components
- General Description
- DTC Information
- Specification
- DTC Inspection
- Wiring Inspection
- Terminal And Connector Inspection
- CAN Communication Line Inspection
- Inspection Procedure For Impedance Measurement When Measuring Impedance, It Is Generally Necessary To Disconnect The Circuit Being Tested From The Power Supply Before Hand. The Vehicle's Battery Should Therefore Be Disconnected And Wait About Four Minutes To Allow All Capacitors In The System To Discharge.
- Resistance Measurement With Matching Resistor
- CAN Resistor Inspection
- CAN Signal Inspection
- Component Inspection
- Verification Of Repair
- ETM
- DTC C1261-04: Steering Angle Sensor Is Not Calibrated
- DTC C1283-02: Lateral G Sensor/Longitudinal G Sensor/Yaw Rate Sensor - Signal Error
- DTC C1285-04: Uncalibrated AX Signal
- DTC C1286-02: Yaw Rate & G Sensor Fail-Check SRSCM
- DTC C1358-01: AVH Not Available Due To EPB In Emergency Release
- DTC C1503-01: TCS Switch Error
- DTC C1542-01: Brake Circuit Error
- DTC C1604-04: ECU Hardware Error
- DTC C160E-08: P-CAN Bus Off
- DTC C1611-08: CAN Time-Out EMS
- DTC C1612-08: CAN Time-Out TCU
- DTC C1613-08: CAN Signal Error EMS
- DTC C1616-08: C-CAN Bus Off
- DTC C1623-08: CAN Time-Out Steering Angle Sensor
- DTC C1627-08: CAN Time-Out 4WD
- DTC C1628-08: CAN Time-Out Cluster
- DTC C1638-08: ACC Communication Error
- DTC C1643-08: CAN Time-Out Yaw Rate & G Sensor
- DTC C1649-08: CAN Time-Out ECM For SCC (Check ECM)
- DTC C1650-08: CAN Signal Error SCC
- DTC C1651-08: CAN Time-Out EPB
- DTC C1652-08: CAN Signal Error EPB
- DTC C1687-08: CAN Time-Out VSM2 (MDPS)
- DTC C1688-08: VSM2 (MDPS) Signal Error
- DTC C1702-04: Variant Coding Error
- DTC C2112-01: Valve Relay Error
- DTC C2228-08: CAN Signal Error TCM For SCC (Check TCM)
- DTC C2380-01: ABS/TCS/ESP Valve Error
- DTC C2402-01: Motor Electrical