Repair Procedure: Removal

Turn the ignition switch off and disconnect the battery (-) terminal.
Remove the RCV control solenoid valve.
(Refer to Engine Control System - "RCV CONTROL SOLENOID VALVE ")
Remove the purge control solenoid valve.
(Refer to Engine Control System - "PURGE CONTROL SOLENOID VALVE ")
Disconnect the variable charge motion actuator connector (A).
Remove the variable charge motion actuator mounting bolts (B).

Fig 1: Locate Variable Charge Motion Actuator Connector And Actuator Mounting Bolts
Courtesy of KIA MOTORS AMERICA, INC.
Remove VCMA rod clip (A) and connection link between flap (B) using screwdriver.

Fig 2: Locate VCMA Rod Clip And Connection Link Between Flap
Courtesy of KIA MOTORS AMERICA, INC.

NOTE: VCMA connection link can be damaged. So, make sure to remove it in a horizontal direction.
Make sure that groove part of the connection link (C) is pointing upward when mounting VCMA.

Fig 3: Locate Connection Link
Courtesy of KIA MOTORS AMERICA, INC.