Repair Procedure: Removal

[Bank 1/Intake] 

1. Turn the ignition switch OFF and disconnect the battery negative (-) terminal.
2. Disconnect the camshaft position sensor connector (A).
3. Remove the mounting bolt (B), and then remove the sensor.

Fig 1: Locate Camshaft Position Sensor Connector And Mounting Bolt

Courtesy of KIA MOTORS AMERICA, INC.

[Bank 1/Exhaust] 

1. Turn the ignition switch OFF and disconnect the battery negative (-) terminal.
2. Remove the air cleaner and intake hose.

   (Refer to Engine Mechanical System - "AIR CLEANER ")

3. Remove the intercooler inlet pipe & hose assembly (A).

   Hose Clamp Bolt: 

   4.9 ~ 6.9 N.m (0.5 ~ 0.7 kgf.m, 3.6 ~ 5.1 lb-ft)

   Pipe Mounting Bolt: 

   14.7 ~ 19.5 N.m (1.5 ~ 2.0 kgf.m, 10.8 ~ 14.5 lb-ft)

   Fig 2: Locate Intercooler Inlet Pipe And Hose Assembly

   Courtesy of KIA MOTORS AMERICA, INC.
4. Disconnect the vacuum hoses (A).
   Fig 3: Locate Vacuum Hoses

   Courtesy of KIA MOTORS AMERICA, INC.
5. Remove the low pressure fuel line mounting nut (A).
   Fig 4: Locate Low Pressure Fuel Line Mounting Nut

   Courtesy of KIA MOTORS AMERICA, INC.
6. Disconnect the camshaft position sensor connector (A).
   Fig 5: Locate Camshaft Position Sensor Connector

   Courtesy of KIA MOTORS AMERICA, INC.
7. Remove the camshaft position sensor (A) after loosening the mounting bolt (B).
   Fig 6: Locate Camshaft Position Sensor And Mounting Bolt

   Courtesy of KIA MOTORS AMERICA, INC.
   Fig 7: Camshaft Position Sensor

   Courtesy of KIA MOTORS AMERICA, INC.