LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2016 >> Sedona LX >> Repair and Diagnosis >> External Pages >> Different car >> Section 249 (Engine Control System Diagnosis - 5.0L (3 Of 4)) >> DTC P0611: Fuel Injector Control Module Performance >> Component Inspection >> Component Inspection

Component Inspection

WARNING: This page is about a different car, the 2017 Kia K900. However, it is still accessible from the selected car via links, so may be relevant.

■ Injector Resistance Inspection 

  1. Ignition "OFF"
  2. Disconnect Battery (-) terminal.
  3. Refer to " INJECTOR " and disconnect Injector connector.
  4. Measure the resistance between Pin No. 2 (Signal) terminal and Pin No. 1 (Ground) terminal of Injector.

    Specification:  Approx. 1.25Ω at 68°F (20°C)

  5. Is measured value within specification?

    YES 

    • Carefully redo this troubleshooting guide steps.
    • If the diagnostics have been performed correctly with no failure found, replace the IDB and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
    CAUTION: When replacing the ECM/PCM, the vehicle equipped with the immobilizer must be performed procedure below.
    [In the case of installing used ECM/PCM]
    1. Perform "ECM Neutral Mode" procedure with GDS. (Refer to "SMART KEY " in BE procedure)
    2. After finishing "ECM Neutral Mode", perform "Key Teaching" procedure with GDS. (Refer to "SMART KEY " in BE procedure)

    [In the case of installing new ECM/PCM]
    Perform "Key Teaching" procedure with GDS. (Refer to "SMART KEY " in BE procedure)
    CAUTION: When replacing the ECM/PCM, the vehicle equipped with the smart key system (Button start) must be performed procedure below.
    [In the case of installing used ECM/PCM]
    1. Perform "ECM Neutral Mode" procedure with GDS. (Refer to "SMART KEY " in BE procedure)
    2. After finishing "ECM Neutral Mode", insert the key (or press the start button) and turn it to the IGN ON and OFF position. Then the ECM/PCM learns the smart key information automatically.

    [In the case of installing new ECM/PCM]
    Insert the key (or press the start button) and turn it to the IGN ON and OFF position. Then the ECM/PCM learns the smart key information automatically.

    NO 

    • Carefully redo this troubleshooting guide steps.
    • If no problems were found with the circuits or connectors, Replace the Injector and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
    CAUTION:
    • Install the component with the specified torques.
    • Note that internal damage may occur when the component is dropped or mistreated.
scientia non olet · About LEMON Manuals