LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2016 >> Sedona LX >> Repair and Diagnosis >> External Pages >> Different car >> Section 215 (Body Control Module Diagnosis) >> DTC B1210-00: Front Left Sensor Fault >> Wiring Inspection >> LIN Communication Line Inspection

LIN Communication Line Inspection

WARNING: This page is about a different car, the 2017 Kia K900. However, it is still accessible from the selected car via links, so may be relevant.

■ Inspection of LIN Communication Line Between Front Left Side Sensor and BCM [PAS (Parking Assist System)] 

  1. Connect GDS and select "Oscilloscope".
  2. IG ON, ENG OFF and Shift lever D
  3. Set an obstacle near the Front Left Side Sensor
  4. Connect T-connector and measure signal waveform between Pin No. 1 (LIN) terminal of Front Left Side Sensor harness connector and chassis ground.

    Specification:  Refer to "Signal Waveform "

  5. Is measured value normal?

    YES 

    • Fault is intermittent caused by BCM [PAS (Parking Assist System)] DTC was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.

    NO 

    • Check a circuit between Front Left Side Sensor and BCM [PAS (Parking Assist System)] and poor connection. And then repair or replace as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
scientia non olet · About LEMON Manuals