Repair Procedures: Installation

WARNING: This page is about a different car, the 2017 Kia K900. However, it is still accessible from the selected car via links, so may be relevant.

Pre-tighten the bracket fixing bolt in dash panel.

Fig 1: Locating Bracket Fixing Bolt In Dash Panel
Courtesy of KIA MOTORS AMERICA, INC.
Install the brake booster and brake pedal member fixing nuts securely.
Tightening Torque:

14.7 ~ 21.6 N.m (1.5 ~ 2.2 kgf.m, 10.8 ~ 15.9 lb-ft)

Fig 2: Installing Brake Booster And Brake Pedal Member Fixing Nuts
Courtesy of KIA MOTORS AMERICA, INC.
Tighten the bolt (B) securely in dash panel.
Tightening Torque:

14.7 ~ 21.6 N.m (1.5 ~ 2.2 kgf.m, 10.8 ~ 15.9 lb-ft)

Fig 3: Locating Bolt In Dash Panel
Courtesy of KIA MOTORS AMERICA, INC.
Install the snap pin (A) and clevis pin (B).

Fig 4: Installing Snap Pin And Clevis Pin
Courtesy of KIA MOTORS AMERICA, INC.
CAUTION:
- Before installing the pin, apply the grease to the clevis pin.
- Use a new snap pin whenever installing.
Install the stop lamp switch securely.
Connect the stop lamp switch connector (A).

Fig 5: Locating Stop Lamp Switch Connector
Courtesy of KIA MOTORS AMERICA, INC.
Adjust the brake pedal height and free play.
Check the brake pedal operation after installing the brake pedal.
Install the crash pad lower panel.
Reconnect the battery negative cable.