Repair Procedures: Replacement

WARNING: This page is about a different car, the 2016 Kia K900. However, it is still accessible from the selected car via links, so may be relevant.

To remove the locking mechanism (A), using a flat-tip screwdriver (B) turn it counter clockwise from the EFD (Emergency Fastening Device) system (C).

Fig 1: Locating Locking Mechanism
Courtesy of KIA MOTORS AMERICA, INC.

Fig 2: Removing Locking Mechanism Using Screwdriver
Courtesy of KIA MOTORS AMERICA, INC.
Remove the front seat track mounting cover.
After loosening the mounting bolts and nuts, remove the front seat assembly (A).
Tightening Torque:

Bolts: 34.3 ~ 53.9N.m (3.5 ~ 5.5kgf.m, 25.3 ~ 39.8lb-ft)

Nuts: 34.3 ~ 49.0N.m (3.5 ~ 5.0kgf.m, 25.3 ~ 36.2lb-ft)

Fig 3: Front Seat Assembly With Mounting Bolts And Nuts
Courtesy of KIA MOTORS AMERICA, INC.
Disconnect the front seat integration connector (A).
[Driver's]

Fig 4: Locating Front Seat Integration Connector (Driver's)
Courtesy of KIA MOTORS AMERICA, INC.

[Passenger's]

Fig 5: Locating Front Seat Integration Connector (Passenger's)
Courtesy of KIA MOTORS AMERICA, INC.
Install in the reverse order of removal.
Information

SEAT MOUNTING BOLT INSTALLATION PROCEDURE
- Set the seat into the most rearward position. Check that each slide is locked, and then tighten the front mounting bolt temporarily.
- Set the seat into most forward position. Check that each slide is locked, and then Tighten the rear mounting bolt completely.
- Set the seat into the most rearward position. Check the front mounting bolt completely.
- Check that the seat operates back and forth smoothy and the locking portion locks properly.