Repair Procedures: Replacement

WARNING: This page is about a different car, the 2017 Kia K900. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect the negative (-) battery cable.
Remove rear bumper cover.
(Proceed to Body - "REAR BUMPER COVER ")
Remove the connector (A).

Fig 1: Locating Connector
Courtesy of KIA MOTORS AMERICA, INC.
Remove the bracket (B) and receiver (C) as loosen the screw (A).

Fig 2: Locating Bracket And Receiver
Courtesy of KIA MOTORS AMERICA, INC.
Loosen the screw (A-2) remove the bracket (B) from the receiver (C).
Tightening Torque:

3.9 ~ 24.5 N.m (0.4 ~ 2.5 kgf.m, 2.9 ~ 18.1 lb-ft)

Fig 3: Removing Bracket From Receiver
Courtesy of KIA MOTORS AMERICA, INC.
Install in the reverse order of removal.
Re-connect the battery, and then turn on the ignition.
CAUTION:
- Firmly fasten the receiver connector until you hear a click.
- Be careful not to damage any parts when moving or loading them.
Replace the receiver, and then perform the learning process using a diagnostic instrument (GDS).
[Wheel Sensor ID Writing (Wireless) Initialization]

Fig 4: Screen Display - Wheel Sensor ID Writing (Wireless) Initialization
Courtesy of KIA MOTORS AMERICA, INC.

[Wheel Sensor ID Writing (Wireless) 1]

Fig 5: Screen Display - Wheel Sensor ID Writing (Wireless) 1
Courtesy of KIA MOTORS AMERICA, INC.

[Wheel Sensor ID Writing (Wireless) 2]

Fig 6: Screen Display - Wheel Sensor ID Writing (Wireless) 2
Courtesy of KIA MOTORS AMERICA, INC.