Repair Procedures: Replacement

WARNING: This page is about a different car, the 2017 Kia K900. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

Put on gloves to protect your hands.

NOTE:

Use a plastic panel removal tool to remove interior trim pieces without marring the surface.
Be careful not to bend or scratch the trim and panels.

Remove the rear console cover.
(Refer to Floor Console - "REAR CONSOLE COVER ")
Remove the console air vent duct (A).

Fig 1: Locating Console Air Vent Duct
Courtesy of KIA MOTORS AMERICA, INC.
Disconnect the console cigar jack connector (A).

Fig 2: Locating Console Cigar Jack Connector
Courtesy of KIA MOTORS AMERICA, INC.
Disconnect the connector (A).

Fig 3: Locating Connector
Courtesy of KIA MOTORS AMERICA, INC.
Remove the console armrest complete (A) after loosening the screws.

Fig 4: Loosening Console Armrest Screws (1 Of 2)
Courtesy of KIA MOTORS AMERICA, INC.

Fig 5: Loosening Console Armrest Screws (2 Of 2)
Courtesy of KIA MOTORS AMERICA, INC.
Remove the console armrest (A) after loosening the screws.

Fig 6: Removing Console Armrest
Courtesy of KIA MOTORS AMERICA, INC.
Install in the reverse order of removal.
Information
- Make sure the connector is connected properly.
- Replace any damage clips.