Smart Key/Card Programming Procedure (PS432)

Publication date: 2015-10-01
Reference number: PS432

SMART KEY/CARD PROGRAMMING PROCEDURE

TECHNICAL SERVICE BULLETIN

Reference Number(s): PS432, Date of Issue: October, 2015

KIA:	K900 (KH)
GROUP:	Electrical

SERVICE INFORMATION

On K900 (KH), up to three (3) Smart Keys (including card type Smart Keys) can be registered to the vehicle. They can be a combination of two (2) Conventional Smart Keys and one (1) Smart Key Card, or two (2) Smart Key Cards and one (1) Conventional Smart Key. Before proceeding with programming using GDS/KDS, have all three (3) Smart-Key Cards present.

NOTE: Any keys/cards not present at the time of programming, will not be functional and will require programming at a later time.

Smart Key Card / Conventional Smart Key Programming Procedure: follow the procedure outlined on KGIS.

NOTE: Pay special attention during programming Smart Key or Card, Do NOT use your finger to press the Stop Start button during sequence. Use the Smart Key or Key Card to fully press the button as shown. Also, when programming the Smart Key Card, use the upper left corner of the card to press the Start Stop Button (SSB). It may be marked with red tape, as shown below.