Component Inspection

■ Check OTS Performance 

1. IG Key "OFF".
2. Disconnect OTS connector.
3. Measure resistance between Pin No. 1 (Signal) terminal and Pin No. 2 (Ground) terminal of the OTS. (Component Side).

   Specification:  Refer to SPECIFICATION 

   The image File (SVG, SWF, GIF) doesn't exist./data/Passenger/KM/KMA/ENG/ETM-Images/KM-KH13-IMAGES-ENG/ 

4. Is the measured value within specification?

   YES 

   • Go to "VERIFICATION OF VEHICLE REPAIR " procedure.

   NO 

   • If no problems were found with the circuits or connectors, replace the OTS and go to "VERIFICATION OF VEHICLE REPAIR " procedure.