WCS Reset

Ignition "OFF", connect GDS.
Ignition "ON" & Engine "OFF".
Perform "WCS Reset " in the "Vehicle S/W Management"
You will see comments and current weight measured.
Make sure the measure weight is caused by occupant or tools or interference.
And then press "ENTER"

Fig 1: Screen Display - Weight Classification System Select
Courtesy of KIA MOTORS AMERICA, INC.

Fig 2: Screen Display - Weight Classification System Reset
Courtesy of KIA MOTORS AMERICA, INC.

Fig 3: Screen Display - Weight Classification System (Reset 1)
Courtesy of KIA MOTORS AMERICA, INC.
The 'WCS Reset' operation will take 3~10 second.
Make sure that there should not be vibration or weight adding to the passenger front seat.

Fig 4: Screen Display - Weight Classification System (Reset 2)
Courtesy of KIA MOTORS AMERICA, INC.

Fig 5: Screen Display - Weight Classification System (Reset 3)
Courtesy of KIA MOTORS AMERICA, INC.

Fig 6: Screen Display - Weight Classification System (Reset 4)
Courtesy of KIA MOTORS AMERICA, INC.

Fig 7: Screen Display - Weight Classification System (Reset 5)
Courtesy of KIA MOTORS AMERICA, INC.
If the 'WCS Reset' operation is finished successfully, you will see the following screen.
Specification: Approx. - 4.0 kg ~ + 4.0 kg

Fig 8: Screen Display - Normal Data Of WCS
Courtesy of KIA MOTORS AMERICA, INC.

Fig 9: Screen Display - Normal Current Data (Empty Data)
Courtesy of KIA MOTORS AMERICA, INC.
Is the displayed parameter the same as the above 9 figure?
YES
- WCS reset is performed correctly
- Go to "Verification Of Vehicle Repair " procedure.
NO
- WCS reset isn't performed correctly.
- Go to the applicable troubleshooting procedure.