LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2016 >> Forte EX >> Repair and Diagnosis >> Brakes >> Traction Control >> Electric Stability Program Diagnosis >> DTC C1605: CAN Hardware Error >> Component Inspection

Component Inspection

  1. Cycle the ignition to "OFF" and "ON" again.
  2. Connect GDS and select "Diagnostic Trouble Codes (DTC)  " mode.
  3. Using a GDS, Clear stored DTCs.
  4. Re-check DTCs in the system.
  5. Are any DTCs present?

    YES 

    • Substitute with a known-good HECU and check for proper operation. If problem is corrected, replace HECU and then go to "Verification Of Vehicle Repair" procedure.
    NOTE: * In case of replacing HECU, perform following procedures.
    1. "ASP Calibration" for steering angle sensor offset correction.
    2. "Longitudinal G-Sensor Calibration" for Longitudinal sensor offset correction (refer to C1285 )
    3. "Perform Variant Coding" (refer to C1702 )

    NO 

    • Fault might be intermittent caused by poor connection in HECU or was repaired and HECU memory was not cleared. Go to "Verification Of Vehicle Repair" procedure.
scientia non olet · About LEMON Manuals