LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2016 >> Forte EX >> Repair and Diagnosis >> Body & Frame >> Seats >> Power Seat Module Diagnosis >> DTC B1602: CAN Error >> DTC Inspection >> Monitor GDS Data

Monitor GDS Data

  1. Connect GDS.
  2. IG "ON" and engine "OFF".
  3. Select "Diagnostic Trouble Codes (DTC)  " mode.
  4. After erase DTC, keep the vehicle condition within "the enable conditions"(Refer to "DTC DETECTING CONDITION " table).
    Fig 1: Display - CAN Error Screen
    G11797647Courtesy of KIA MOTORS AMERICA, INC.
  5. Is the same DTC occurred again?

    YES 

    • Go to next procedure.

    NO 

    • Fault is intermittent caused by poor contact in the PSM's connector or was repaired and PSM memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and then go to "Verification Of Vehicle Repair " procedure.
scientia non olet · About LEMON Manuals