Monitor GDS Data

WARNING: This page is about a different car, the 2017 Kia Soul EV. However, it is still accessible from the selected car via links, so may be relevant.

Ignition "OFF", connect GDS.
Ignition "ON" (Power Button LED "Red"), select "Current Data" mode.
Monitor the "Read Class Status" parameter on the GDS.

Fig 1: Scantool Display - Read Class Status (Passenger Unoccupied)
Courtesy of KIA MOTORS AMERICA, INC.

Fig 2: Scantool Display - Read Class Status (Passenger Occupied)
Courtesy of KIA MOTORS AMERICA, INC.
Has a problem been found?
YES
- Go to "BODY SENSOR RESET " procedure.
NO
- Fault is intermittent caused by poor contact in the part's and/or SRSCM connector or was repaired and SRSCM memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage.