LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2015 >> Soul Base, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 149 (Vehicle Motor Control System Diagnosis) >> DTC P0706: Transmission Range Sensor Circuit Range/Performance >> Component Inspection

Component Inspection

WARNING: This page is about a different car, the 2017 Kia Soul EV. However, it is still accessible from the selected car via links, so may be relevant.

■ Inhibitor Switch Inspection 

  1. Ignition "OFF".
  2. Disconnect safety plug from the main battery (Wait for 15 minutes after OFF).
  3. Disconnect Inhibitor Switch harness connector.
  4. Measure resistance between Pin No. 3 (Power) and Pin No. 8 (P position) terminals of Inhibitor Switch. (P range position status)
  5. Measure resistance between Pin No. 3 (Power) and Pin No. 4 (R position) terminals of Inhibitor Switch. (R range position status)
  6. Measure resistance between Pin No. 3 (Power) and Pin No. 7 (N position) terminals of Inhibitor Switch. (N range position status)
  7. Measure resistance between Pin No. 3 (Power) and Pin No. 10 (D position) terminals of Inhibitor Switch. (D range position status)
  8. Measure resistance between Pin No. 3 (Power) and Pin No. 6 (B position) terminals of Inhibitor Switch. (B range position status)

    Specification:  Approx. 1 Ω below

  9. Is the measured resistance within specifications?

    YES 

    NO 

    • Carefully re-do this troubleshooting guide steps.
    • Problem still occurs, replace, Inhibitor Switch and then go to, "VERIFICATION OF VEHICLE REPAIR " procedure.
scientia non olet · About LEMON Manuals