LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2015 >> Soul Base, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 171 (Supplemental Restrain System Control Module (SRSCM) And Sensors) >> SRS Control Module (SRSCM) >> Repair Procedures >> Installation

Repair Procedures: Installation

WARNING: This page is about a different car, the 2017 Kia Soul EV. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the ignition key from the vehicle.
  2. Disconnect the battery negative cable and wait for at least three minutes before beginning to work.
  3. Install the SRSCM with the SRSCM mounting bolts.

    Tightening Torque (SRSCM Mounting Bolt): 

    7.8 ~ 9.8 N.m (0.8 ~ 1.0 kgf.m, 5.7 ~ 7.3 lb-ft)

    Fig 1: Locating SRSCM Mounting Bolts
    G11933767Courtesy of KIA MOTORS AMERICA, INC.
    NOTE:
    • Use new mounting bolts when replacing the SRSCM after a collision.
    • When installing the airbag wiring harness, ground points (C) must be installed.
  4. Connect the SRSCM harness connector.
  5. Install the rear heating joint duct.
  6. Install the floor console.

    (Refer to Body - "FLOOR CONSOLE ")

  7. Reconnect the battery negative cable.
  8. After installing the SRSCM, confirm proper system operation:
    • Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
    CAUTION: SRSCM senses vehicle roll overs. SAB, CAB, BPT may deploy if a technician moves the SRSCM from the vehicle in IGN ON state. For this reason, turn the IGN OFF before safely removing the SRSCM from the vehicle.
scientia non olet · About LEMON Manuals