Ground Circuit Inspection
- IG "OFF" & Disconnect OTS connector.
- IG "ON".
- Measure voltage between Pin No. 1(signal) terminal of OTS harness connector and chassis ground.(A)
- Measure voltage between Pin No. 1(signal) terminal and Pin No. 1(ground) terminal of the OTS.(B)
Specification: "A" - "B" = Below 200mV
- Is the measured voltage within specification?
YES
- Go to "COMPONENT INSPECTION " procedure.
NO
- Repair or replace as necessary and then, go to "Verification Of Vehicle Repair " procedure.