LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2015 >> Sedona L >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Airbag Modules & Clock Spring >> Side Airbag (SAB) Module >> Repair Procedures >> Installation

Repair Procedures: Installation

CAUTION: When installing the harness wires, be sure that they are not pinched or interfering with other parts.
NOTE:
  • Do not open the lid of the side airbag cover.
  • Make sure that the airbag assembly cover is installed properly. Improper installation may hinder proper deployment.
  1. Remove the ignition key from the vehicle.
  2. Disconnect the battery negative cable and wait for at least thirty seconds.
  3. Install the new seat back assembly.
  4. Install the front seat assembly.

    (Refer to Body - "FRONT SEAT ASSEMBLY ")

  5. Fully recline and slide the front seat forward, and make sure that the harness wires are not pinched or interfering with other parts.
  6. Reconnect the battery negative cable.
  7. After installing the side airbag (SAB), confirm proper system operation:
    • Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
scientia non olet · About LEMON Manuals