Component Inspection

Visual Check
1. IG KEY "OFF".
2. Disconnect HO2S (S2)_DOWN connector.
3. Check that HO2S (S2)_DOWN is contaminated or damaged by foreign materials.
4. Has a problem been found?
  YES
  - Many malfunctions in the electrical system are caused by poor harness (es) and terminals. Faults can also be caused by interference from other electrical systems, and mechanical or chemical damage. So, check poor connections and the related circuit between ECM/PCM and component thoroughly. Repair as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.
  NO
  - Substitute with a known - good HO2S (S2)_DOWN and check for proper operation. If the problem is corrected, replace HO2S (S2)_DOWN and go to "VERIFICATION OF VEHICLE REPAIR " procedure.