Control Circuit Inspection
- Check short to ground in harness
- IG "OFF". Disconnect VIS 1 connector and PCM connector.
- Measure resistance between control terminal of VIS 1 harness connector and chassis ground.
Specification: Infinite
- Is the measured resistance within specification?
YES
- Go to "CHECK OPEN IN HARNESS " as follows.
NO
- Repair short to ground in harness. Go to "VERIFICATION OF VEHICLE REPAIR " procedure.
- CHECK OPEN IN HARNESS
- IG "OFF". Disconnect VIS 1 connector and PCM connector.
- Measure resistance between control terminal of VIS 1 harness connector and VIS 1 control terminal of PCM harness connector.
Specification: Below 1Ω
- Is the measured resistance within specification?
YES
- Go to "COMPONENT INSPECTION " procedure.
NO
- Repair open in harness, and go to "VERIFICATION OF VEHICLE REPAIR " procedure.