Repair Procedures: Removal

WARNING: This page is about a different variant/trim than selected.

Turn the ignition switch OFF and disconnect the battery negative (-) cable.
Disconnect the engine coolant temperature sensor connector (A).

Fig 1: Identifying Engine Coolant Temperature Sensor Connector
Courtesy of KIA MOTORS AMERICA, INC.
Remove the spring clip (A), and then pull the sensor from the water temperature control assembly.

Fig 2: Identifying Spring Clip
Courtesy of KIA MOTORS AMERICA, INC.

CAUTION: Note that engine coolant may be flowed out from the water temperature control assembly when removing the sensor.

Installation
CAUTION:
- Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
CAUTION:
- Apply the engine coolant to the O-ring.
CAUTION:
- Insert the sensor in the installation hole and be careful not to damage.

Install in the reverse order of removal.
CAUTION:
- Supplement the engine coolant. (Refer to "COOLANT ")