Common Specs & Procedures Index
RIO COMMON SPECS & PROCEDURES
| System | Specification/Procedure | ||
|---|---|---|---|
| Air Conditioning | |||
| Service | SPECIFICATION | ||
| Torque | TIGHTENING TORQUES | ||
| Axle Nut/Hub Nut | 144.6 ~ 202.5 ft. lbs. (196.1 ~ 274.5) | ||
| Battery | BATTERY and CHARGING SYSTEM | ||
| Brakes | |||
| Bleeding Sequence | BRAKE SYSTEM BLEEDING | ||
| Disc Brakes | SPECIFICATIONS | ||
| Drum Brakes | SPECIFICATIONS | ||
| Torque | |||
| Front | Refer to TIGHTENING TORQUES . | ||
| Rear | Refer to TIGHTENING TORQUES . | ||
| Charging | |||
| Generator | Refer to ALTERNATOR and SPECIFICATION . | ||
| Torque | N/A | ||
| Drive Belts | |||
| Adjustment | REPAIR PROCEDURES | ||
| Belt Routing | REPAIR PROCEDURES | ||
| Engine Cooling | |||
| General Service Specifications | See Cooling System in GENERAL INFORMATION table under SPECIFICATIONS . | ||
| Radiator Cap Pressure | 14-18 psi | ||
| Thermostat R & I | THERMOSTAT | ||
| Water Pump R & I | WATER PUMP | ||
| Engine Mechanical | |||
| Compression | COMPRESSION PRESSURE INSPECTION | ||
| Oil Pressure | 100 kPa (1.0 kg/cm2 , 14.5 psi) or above at 800 RPM with Oil temperature in oil pan: 110±2°C (230± 36°F). | ||
| Overhaul | SPECIFICATIONS . | ||
| Torque | SPECIFICATIONS | ||
| Fluid Specifications | See FLUIDS under MAINTENANCE tab. From within Manager or Service Writer, click the "30/60/90 Interval" or "Maint." button. | ||
| Flywheel/Flexplate Torque | 52.8-55.7 ft. lbs. (71.6-75.5 N.m) | ||
| Fuel System | |||
| Fuel Filter Location | Fuel filter is part of fuel pump. | ||
| Fuel Filter R & I | Refer to REMOVAL . | ||
| Pressure Specification | 429 ~ 469 kPa (4.38 ~ 4.79 kgf/cm2 , 62.3 ~ 68.1 psi) | ||
| Fuel Pressure Test Procedure | FUEL PRESSURE TEST (LOW PRESSURE SYSTEM) | ||
| Fuel Pressure Release Procedure | RELEASE RESIDUAL PRESSURE IN FUEL LINE | ||
| Ignition | |||
| Firing Order & Cylinder Identification | SPECIFICATIONS | ||
| Ignition Wires (Resistance) | N/A | ||
| Ignition Wires (Routing) | N/A | ||
| Spark Plugs | SILZKR6B10E | ||
| Starting | |||
| Starter | SPECIFICATION | ||
| Torque | 36.2-47.0 ft. lbs. (49.0-63.7 N.m) | ||
| Wheel Alignment | |||
| Adjustment Specifications | FRONT WHEEL ALIGNMENT REAR WHEEL ALIGNMENT |
||
| Torque | TIGHTENING TORQUES | ||
| Wheel & Tire | |||
| Lug Nut Torque | 65-79 ft. lbs. (88-108 N.m) | ||