DTC Information: DTC Detecting Condition

DTC DETECTING CONDITION

Item		Detecting Condition	Possible Cause
DTC Strategy		Short to Battery or Open circuit	Open in ground circuit Short to battery in signal circuit Poor connection or damaged harness Faulty TPS1
Case 1	Enable Conditions	Ignition "ON"
Case 1	Threshold Value	TPS > 4.9V
Case 1	Enable Conditions	Ignition "ON" In idle status Target throttle angle < 58% MAF Limp home detected or TPS2 failure detected
Case 1	Threshold Value	TPS1 > 3.0V
Diagnostic Time		0.05 seconds
Mil On Condition		1 Drive Cycles
Limp-Home		Forced limited power mode : When the DTC is set, the PCM reduces engine torque by 25% of normal value. The PCM uses TPS2 signal to monitor the controlled opening angle of the throttle valve.