LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2013 >> Soul Base, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 55 (Supplemental Restraint System Control Module (SRSCM) & Sensors) >> SRS Control Module (SRSCM) >> Repair Procedures >> Installation

Repair Procedures: Installation

WARNING: This page is about a different car, the 2013 Kia Sportage and 2012 Kia Sportage. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the ignition key from the vehicle.
  2. Disconnect the battery negative cable and wait for at least three minutes before beginning work.
  3. Install the SRSCM with the SRSCM mounting nuts.

    Tightening torque: 

    6.8 - 9.2 N.m (0.7 - 0.9 kgf.m, 5.0 - 6.8 lb-ft)

    Fig 1: Locating SRSCM Mounting Nuts
    G07426302Courtesy of KIA MOTORS AMERICA, INC.
    NOTE: Use new mounting bolts when replacing the SRSCM after a collision.
  4. Connect the SRSCM harness connector.
  5. Install the shift lever assembly. Refer to SHIFT LEVER .
  6. Install the floor console upper cover. Refer to CONSOLE .
  7. Connect the DAB, PAB, SAB, CAB and BPT connectors.
  8. Reconnect the battery negative cable.
  9. After installing the SRSCM, confirm proper system operation:
  1. Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
CAUTION: SRSCM can sense a vehicle rollover. SAB, CAB, BPT can deploy if mechanic moves the SRSCM on vehicle during IGN ON state. For this reason, be sure to turn the IGN OFF and then remove the SRSCM from vehicle.
scientia non olet · About LEMON Manuals