LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2013 >> Soul Base, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 55 (Supplemental Restraint System Control Module (SRSCM) & Sensors) >> Front Impact Sensor (FIS) >> Repair Procedures >> Installation

Repair Procedures: Installation

WARNING: This page is about a different car, the 2013 Kia Sportage and 2012 Kia Sportage. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
  • Do not turn the ignition switch ON and do not contact the battery cable while replacing the front impact sensor.
  1. Install the new front impact sensor.
  2. Tighten the front impact sensor mounting bolt.

    Tightening torque: 

    7.0 - 9.0 Nm (0.7 - 0.9 kgf.m, 5.1 - 6.6 lb.ft)

  3. Connect the front impact sensor connector.
  4. Install the air duct and air cleaner assembly. (Driver front impact sensor only)
  5. Reconnect the battery negative cable.
  6. After installing the Front Impact Sensor, confirm proper system operation:
  1. Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
scientia non olet · About LEMON Manuals