Repair Procedures (F21): Installation

WARNING: This page is about a different car, the 2011 Hyundai Veracruz. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: Must use a new O-ring (47354-39300).

Temporarily install the transfer case assembly to the transaxle and then tighten the six mounting bolts (A).
Tightening torque:

62-67 N.m (6.2-6.7 kgf.m, 44.8-48.5 lb-ft)

Fig 1: Identifying Transfer Case Assembly Mounting Bolts (1 Of 2)
Courtesy of HYUNDAI MOTOR CO.

Fig 2: Identifying Transfer Case Assembly Mounting Bolts (2 Of 2)
Courtesy of HYUNDAI MOTOR CO.
Install the four mounting bolts (A) of the transfer case bracket.
Tightening torque:

47-51 N.m (4.7-5.1 kgf.m, 34.0-36.9 lb-ft)

Fig 3: Identifying Transfer Case Bracket Mounting Bolts
Courtesy of HYUNDAI MOTOR CO.
Remove the filler plug (A).

Fig 4: Identifying Filler Plug
Courtesy of HYUNDAI MOTOR CO.
After refilling the fluid amount of the specified, tighten the filler plug.
Specification: API GL-5, SAE 75W/90

Quantity: Approx 0.8 L
Install the right driveshaft to the transfer case. (refer to INSTALLATION )
Install the propeller shaft (A) to the transfer case.
Tightening torque:

50-70 N.m (5.0-7.0 kgf.m, 36.2-50.6 lb-ft)

Fig 5: Identifying Propeller Shaft
Courtesy of HYUNDAI MOTOR CO.
Install the front muffler (A). (refer to INTAKE AND EXHAUST SYSTEM )
Tightening torque:

40-60 N.m (4.0-6.0 kgf.m, 28.9-43.4 lb-ft)

Fig 6: Identifying Front Muffler
Courtesy of HYUNDAI MOTOR CO.
Connect the (-) terminal to the battery.