Repair procedures: Installation
WARNING: This page is about a different variant/trim than selected.
CAUTION:
- Install the component with the specified torques.
- Note that internal damage may occur when the component is dropped. In this case, use it after inspecting.
CAUTION:
The VCM actuator has to be installed at the fully closing position of the VCM valve.
If it doesn't, the VCM coupling of the VCM shaft can't be put in the VCM actuator.
If it doesn't, the VCM coupling of the VCM shaft can't be put in the VCM actuator.
- Installation is reverse of removal.
Variable charge motion actuator installation bolt:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)