Connector (ENGA-B)
WARNING: This page is about a different variant/trim than selected.
| Pin No. | Description | Condition | Type | Level |
|---|---|---|---|---|
| 1 | Power ground | Idle | DC | Max. 50mV |
| 2 | Power ground | Idle | DC | Max. 50mV |
| 3 | Battery power (B+) | IGOFF | DC | Max. 0.5V |
| IGON | Battery Voltage | |||
| 4 | Power ground | Idle | DC | Max. 50mV |
| 5 | Battery power (B+) | IGOFF | DC | Max. 0.5V |
| IGON | Battery Voltage | |||
| 6 | Battery power (B+) | IGOFF | DC | Max. 0.5V |
| IGON | Battery Voltage | |||
| 7 | - | |||
| 8 | - | |||
| 9 | - | |||
| 10 | Brake Test Switch signal input | Swich ON | Digital | Battery voltage |
| Switch OFF | Min. -0.3V ~Max. 0.5V | |||
| 11 | - | |||
| 12 | - | |||
| 13 | Sensor power (+5V) | IGOFF | DC | Max. 0.5V |
| IGON | Min. 4.75V ~ Max. 5.25V | |||
| 14 | Head lamp switch signal input | |||
| 15 | Electrical load signal input | Idle | PWM | Battery voltage |
| 16 | Alternator PWM control output | IGOFF | PWM | Battery voltage |
| IGON | Max. 0.5V | |||
| 17 | - | |||
| 18 | Cooling Fan Relay [High] control output | IGOFF | DC | Battery voltage |
| IGON | Min.-0.3V~Max. 1.2V | |||
| 19 | Immobilizer Lamp control output | Lamp ON | DC | Min.-0.3V~Max. 1.2V |
| Lamp OFF | Battery voltage | |||
| 20 | ETC Motor [+] control output | Idle | PWM | Operating freq.: 1000Hz (estimated) |
| Forward direction Turn on: Battery voltage Freewheeling: Max. 0.1V | ||||
| Reverse direction Turn on: Max. 0.1V Freewheeling: Max. 0.1V | ||||
| 21 | ETC Motor [-] control output | Idle | PWM | Operating freq.: 1000Hz (estimated) |
| Forward direction Turn on: max 0.1V Freewheeling: max 0.1V | ||||
| Reverse direction Turn on: Battery voltage Freewheeling: max 0.1V | ||||
| 22 | Electrical load [Wiper] signal input | Idle | PWM | Battery voltage |
| 23 | Injector (Cylinder #1) control output | Idle | DC | Hi: Battery voltage |
| LO: Max. 0.5V | ||||
| 48~50V | ||||
| 24 | - | |||
| 25 | - | |||
| 26 | - | |||
| 27 | Brake Light Switch signal input | Swich ON | Digital | Battery voltage |
| Switch OFF | Min. -0.3V ~Max. 0.5V | |||
| 28 | - | |||
| 29 | Sensor power (+5V) | IGOFF | DC | Max. 0.5V |
| IGON | Min. 4.75V ~ Max. 5.25V | |||
| 30 | Sensor power (+5V) | IGOFF | DC | Max. 0.5V |
| IGON | Min. 4.75V ~ Max. 5.25V | |||
| 31 | - | |||
| 32 | LIN communication signal input | |||
| 33 | Cooling Fan Relay [Low] control output | IGOFF | PWM | Battery voltage |
| IGON | Min.-0.3V~Max. 1.2V | |||
| 34 | - | |||
| 35 | Brake Booster Vacuum Pressure Sensor (BBVPS) signal input | |||
| 36 | Sensor ground | Idle | DC | Max. 50mV |
| 37 | - | |||
| 38 | - | |||
| 39 | ISG OFF switch signal input | |||
| 40 | Injector (Cylinder #3) control output | Idle | DC | Hi: Battery voltage |
| LO: Max. 0.5V | ||||
| 48~50V | ||||
| 41 | Battery power (B+) | IGOFF | DC | Max. 0.5V |
| IGON | Battery Voltage | |||
| 42 | - | |||
| 43 | - | |||
| 44 | Sensor ground | Idle | DC | Max. 50mV |
| 45 | A/C Pressure Transducer (APT) signal input | |||
| 46 | Sensor ground | Idle | DC | Max. 50mV |
| 47 | Sensor ground | Idle | DC | Max. 50mV |
| 48 | - | |||
| 49 | - | |||
| 50 | - | |||
| 51 | - | |||
| 52 | Start Motor control switch | Switch ON | Digital | Battery voltage |
| Switch OFF | Min. -0.3V ~ Max. 0.5V | |||
| 53 | Main Relay control output | IGOFF | DC | Min.-.03V~Max. 1.2V |
| IGON | Battery Voltage | |||
| 54 | - | |||
| 55 | - | |||
| 56 | - | |||
| 57 | Injector (Cylinder #4) control output | Idle | DC | Hi: Battery voltage |
| LO: Max. 0.5V | ||||
| 48~50V | ||||
| 58 | - | |||
| 59 | - | |||
| 60 | C-CAN [Low] | RECESSIVE | Pulse | 2.0~3.0V |
| DOMINANT | 0~0.5V | |||
| 61 | - | |||
| 62 | - | |||
| 63 | Accelerator Position Sensor (APS) 1 signal input | Idle | Analog | Min. 0.6V~Max. 4.3V |
| 64 | Accelerator Position Sensor (APS) 2 signal input | Idle | Analog | Min. 0.3V~Max. 2.1V |
| 65 | - | |||
| 66 | - | |||
| 67 | A/C Compressor Relay control output | Relay OFF | DC | Battery voltage |
| Relay ON | Min.-0.3V~Max. 1.2V | |||
| 68 | Variable Intake Solenoid (VIS) Valve control output | |||
| 69 | Start relay control output | |||
| 70 | Fuel Pump Relay control output | Relay OFF | DC | Battery Voltage |
| Relay ON | Min.-.03V~Max. 1.2V | |||
| 71 | Engine speed signal output | Idle | Frequency | Around 26Hz at 850rpm, idle |
| Around 16Hz at 3000rpm | ||||
| 72 | - | |||
| 73 | ISG OFF lamp signal output | |||
| 74 | Injector (Cylinder #2) control output | Idle | DC | Hi: Battery voltage |
| LO: Max. 0.5V | ||||
| 48~50V | ||||
| 75 | Battery power (B+) | IG OFF | DC | Max. 0.5V |
| IG ON | Battery Voltage | |||
| 76 | - | |||
| 77 | C-CAN [High] | RECESSIVE | Pulse | 2.0~3.0V |
| DOMINANT | 2.75~4.5V | |||
| 78 | Vehicle speed signal input | Idle | Frequency | Duty rate 40% ~ 60% |
| 79 | - | |||
| 80 | Sensor ground | Idle | DC | Max. 50mV |
| 81 | Fuel Tank Pressure Sensor (FTPS) signal input | Idle | Analog | Min. 0.4V~Max. 4.6V |
| 82 | Start Motor control switch | Switch ON | Digital | Battery voltage |
| Switch OFF | Min. -0.3V ~ Max. 0.5V | |||
| 83 | Fuel Level Sensor (FLS) signal input | Idle | Analog | Min. 0.2V~Max. 4.7V |
| 84 | CVVT Oil Control (OCV) Valve [Bank 1/Exhaust] control output | Idle | PWM | Operating freq. range: 300Hz Duty rate: 0% ~ 100% |
| 85 | CVVT Oil Control (OCV) Valve [Bank 1/Intake] control output | Idle | PWM | Operating freq. range: 300Hz Duty rate: 0% ~ 100% |
| 86 | Purge Control Solenoid Valve (PCSV) control output | Relay OFF | DC | Battery voltage |
| Relay ON | Max. 1.76V | |||
| 87 | Canister Close Valve (CCV) control output | Inactive | DC | Min.-0.3V ~ Max. 1.2V |
| Active | Battery voltage | |||
| 88 | - | |||
| 89 | - | |||
| 90 | Heated Oxygen Sensor (HO2S) [Bank 1/Sensor 2] Heater control output | Relay OFF | DC | Battery voltage |
| Relay ON | Max. 0.5V | |||
| 91 | Heated Oxygen Sensor (HO2S) [Bank 1/Sensor 1] Heater control output | Relay OFF | DC | Battery voltage |
| Relay ON | Max. 0.5V |