LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2013 >> Soul Base, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 17 (Engine Control System - 2.0L) >> Accelerator Position Sensor (APS) >> Repair procedures >> Removal

Repair procedures: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Turn the ignition switch OFF and disconnect the negative (-) battery cable.
  2. Disconnect the accelerator position sensor connector (A).
  3. Remove the installation nuts (B), and then remove the accelerator pedal module.
    Fig 1: Identifying Accelerator Position Sensor Connector And Nuts
    G08331069Courtesy of KIA MOTORS AMERICA, INC.
scientia non olet · About LEMON Manuals