Check Open In Signal Circuit

IG key OFF.
Disconnect 'CRUISE REMOCON SWITCH' connector and Cluster connector.
Measure resistance between 'Signal (Cruise sw)' terminal of 'CRUISE REMOCON SWITCH' harness connector and 'Signal (Cruise sw)' terminal of PCM connector.
Specification : Below 1.0Ω

For 2012

Fig 1: Measuring Resistance Between 'Signal (Cruise Sw)' Terminal Of 'Cruise Remocon Switch' Harness Connector & PCM Connector
Courtesy of KIA MOTORS AMERICA, INC.

For 2013 refer to ETM
Is the measured value within specification?
YES
- Go to "COMPONENT INSPECTION " procedure.
NO
- Repair open between 'Signal (Cruise sw)' terminal of 'CRUISE REMOCON SWITCH' harness connector and 'Signal (Cruise sw)' terminal of PCM connector, and go to "VERIFICATION OF VEHICLE REPAIR " procedure.