Repair procedures: Disassembly

WARNING: This page is about a different car, the 2011 Hyundai Veracruz. However, it is still accessible from the selected car via links, so may be relevant.

If the front bearing needs replacing, remove the pulley with a hexagonal wrench.
Remove the generator cover (A) after removing the three nuts (B).

Fig 1: Identifying Generator Cover
Courtesy of HYUNDAI MOTOR CO.
Remove the brush holder (A).

Fig 2: Identifying Brush Holder
Courtesy of HYUNDAI MOTOR CO.
Remove the four screws, the rectifier (B) and the rubber seal (C).

Fig 3: Identifying Screws And Rectifier
Courtesy of HYUNDAI MOTOR CO.
Remove the four nuts (A) and insulators (B).

Fig 4: Identifying Insulators Nuts
Courtesy of HYUNDAI MOTOR CO.

Fig 5: Identifying Insulators
Courtesy of HYUNDAI MOTOR CO.
Remove the rear bracket assembly (A) and washer (B).

Fig 6: Identifying Rear Bracket Assembly
Courtesy of HYUNDAI MOTOR CO.
Remove the rotor (A) from the stator and front frame assembly (B).

Fig 7: Identifying Rotor
Courtesy of HYUNDAI MOTOR CO.