LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2012 >> Soul Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 21 (Supplemental Restraint System (SRS) Control Module & Sensors) >> SRS Control Module (SRSCM) >> Repair Procedures >> Installation

Repair Procedures: Installation

WARNING: This page is about a different car, the 2011 Hyundai Veracruz. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the ignition key from the vehicle.
  2. Disconnect the battery negative cable and wait for at least three minutes before beginning work.
  3. Install the SRSCM with the SRSCM mounting nuts.

    Tightening torque (SRSCM Mounting bolt): 

    8 ~ 12 N.m (0.8 ~ 1.2 kgf.m, 5.9 ~ 8.9 lb-ft)

    NOTE: Use new mounting bolts when replacing the SRSCM after a collision.
  4. Connect the SRSCM harness connector.
  5. Install the heater ducts and floor console. (Refer to FLOOR CONSOLE REPLACEMENT )
  6. Connect the DAB, PAB, SAB, CAB and BPT connectors.
  7. Reconnect the battery negative cable.
  8. After installing the SRSCM, confirm proper system operation:
    1. Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
scientia non olet · About LEMON Manuals