LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2012 >> Sorento Base, 2.4L Eng VIN 1, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 105 (Airbag Modules & Clock Spring) >> Driver Airbag (DAB) Module And Clock Spring >> Repair Procedures >> Removal

Repair Procedures: Removal

WARNING: This page is about a different car, the 2015 Kia Sorento. However, it is still accessible from the selected car via links, so may be relevant.
  1. Set the front tires straight-ahead before removing the steering wheel.
    CAUTION: If the steering wheel and the front tires are not set straight ahead together, it affects the number of circulation of steering wheel and the cable inside the clock spring is possible to be damaged.
  2. Disconnect the battery negative cable.
    NOTE: After disconnecting the battery negative cable, wait for at least thirty seconds.
  3. Release the connector locking pin, then disconnect the driver airbag module connector (B).
    CAUTION: The removed airbag module should be stored in a clean, dry place with the pad cover face up.
  4. Remove the steering wheel and steering wheel column shroud. (Refer to "STEERING COLUMN AND SHAFT ")
    Fig 1: Steering Column Shroud
    G09766129Courtesy of KIA MOTORS AMERICA, INC.
  5. Disconnect the clock spring and horn connector, then remove the clock spring.
    Fig 2: Clock Spring & Horn Connector
    G09766130Courtesy of KIA MOTORS AMERICA, INC.
scientia non olet · About LEMON Manuals