LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2012 >> Sorento Base, 2.4L Eng VIN 1, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 105 (Airbag Modules & Clock Spring) >> Curtain Airbag (CAB) Module >> Repair Procedures >> Installation

Repair Procedures: Installation

WARNING: This page is about a different car, the 2015 Kia Sorento. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the ignition key from the vehicle.
  2. Disconnect the battery negative cable and wait for at least thirty seconds.
  3. Tighten the curtain airbag mounting bolts.

    Tightening torque 

    : 6.9 ~ 8.8 Nm (0.7 ~ 0.9 kgf.m, 5.1 ~ 6.5 lb.ft)

    CAUTION:
    • Never twist the airbag module when installing it. If the module is twisted, airbag module may operate abnormally.
  4. Connect the curtain airbag connector.
  5. Install the roof trim. (Refer to "INTERIOR TRIM ")
  6. Reconnect the battery negative cable.
  7. After installing the curtain airbag (CAB), confirm proper system operation:
    1. Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
scientia non olet · About LEMON Manuals