LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2012 >> Sedona LX >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Airbag Modules & Clock Spring >> Passenger Airbag (PAB) Module >> Repair Procedures >> Installation

Repair Procedures: Installation

  1. Disconnect the negative (-) cable from battery and wait for at least three minutes.
  2. Remove ignition key from the vehicle.
  3. Place a Passenger Airbag (PAB) on the crash pad and tighten the PAB mounting nuts.

    Tightening Torque

    : 0.7 ~ 0.8 kgf.m (7.0 ~ 8.0 N.m, 5.2 ~ 5.9 lb.ft)

  4. Install the heater duct to the crash pad.
  5. Install the crash pad. Refer to CRASH PAD REPLACEMENT .
  6. Tighten the PAB mounting bolts.

    Tightening Torque

    : 1.2 ~ 1.3 kgf.m (12.0 ~ 13.0 N.m, 8.9 ~ 9.6 lb.ft)

  7. Connect the PAB harness connector to the SRS main harness connector.
  8. Reinstall the glove box. Refer to GLOVE BOX REPLACEMENT .
  9. Reconnect the battery negative cable.
  10. After installing the PAB, confirm proper system operation:
  1. Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
scientia non olet · About LEMON Manuals